High Bay Occupancy Sensors
To increase energy savings by up to 30% Fluorescent High Bays can be used with occupancy sensors, daylight sensors and muti-level controls without compromising the fixtures performance.
Our High Bay occupancy sensors are specifically designed for high mounted areas. The sensors install directly to the high bay, and turns individual light fixtures on or off based on occupancy. Choose from three lenses for use in either a 360° high-bay or 360° low-bay general area or an aisle way, with reliable coverage up to 40 ft. mounting heights. Combination occupancy and daylight sensors will turn lights on/off based on occupancy, and will force lights off when sufficient daylight is available for additional energy savings.
Operation
If no motion is detected for a field adjustable time delay, on/off sensors break power to the ballast(s). When multiple ballasts are specified, on/off sensors may control one or all ballasts.
- Quick and easy installation - The OSFHU-ITW Sensor provides a self-contained, line-voltage occupancy sensor that connects to individual fixtures using standard 1/2” knockouts.
- Convenient LED status indicator - A green LED provides confirmation that the occupancy sensor is functioning properly
- Snap-in install feature - The threaded nipple also is provided with an integral catch for Double-D 1/2 inch knock-outs.
- Timer settings - 5-10-15-20 unit is shipped set to 30 second default
- Accommodates high-bay 20 - 40 foot mounting heights and Masking tape provided with each unit to “block” area where sensing detection is not desired
- Zero-crossing circuitry for greater reliability - The built-in relay uses zero-crossing circuitry to provide reliable, long-life operation
- 120 volt / 800 VAC
- 277 volt / 1200 VAC
|
